Sandwich Panel Roll Forming Device, EPS Sandwich Panel Line, Mineral Wool Sandwich Panel line, Sandwich Panel Roll Forming Line

sandwich panel machine

Sandwich panel production line is particularly made for making insulation composite board. With stepless velocity regulation technique, it is ready to produce corrugated composite panel successfully at one particular time. Sandwich panel roll forming machine has been an indispensable system in fabricating roof panels and wall panels in plants and warehouses, between other structures.

Features

one. The motor electrical power of the sandwich panel roll forming line is 4kw, and the generation velocity reaches 6m/min. With the stepless speed regulation method, the effectiveness of the roll forming line is optional inside -6m/min.

two. When creating EPS sandwich panel, the velocity is typically controlled at two-6 m/min. It will be marginally reduced for making rock wool board (depends on actual demands)

3. The composite panel creation line is geared up with K-9 glue metering pump, featuring low rotating velocity and high accuracy. The glue is fed at a fee of .one-two. kg/min. It is managed by frequency converter.

4. The thickness of the composite panel the roll forming device can generate is varied from 50mm to 250mm. By adjusting the higher and reduced rack, and the length among the cutter holder and the content feeding rack, we can get sandwich boards with various thickness and requirements.

five. Complete put in ability: 34KW complete weight (such as accessories): 17.5t.

6. Dimension of the panel roll forming device: 12500 (16000 for rock wool boards) X2200X2800 the roll previous for five variety EPS sandwich panel adopts 23 rubber shafts and 160X80 square tubes with thickness of 6mm the roll previous for 7 sort composite rock wool panel employs forty five rubber shafts, and upper and decrease independent glue offer. It is outfitted with 1.7m rock wool panel conveyor belt, with the diameter of the push shaft to be 50mm length of the equipment frame is up to 9m the roll previous is welded with 180X80 sq. tubes which thickness is 8mm.

Requirements for Factories:

The factories the place our EPS sandwich panel production line are utilized can be both flatroof or sloped-roof variety. The height of the cornice must be greater than 5m, and the successful width ought to be at least 45m. The ground of the manufacturing facility must be flat and concrete. For foundation of the roll forming line, it is essential to be to be 380V, and the overall set up power is 34kw. It is necessary for the factory to be geared up with .four-.6MPa compressed air source and illumination units. The roll forming machine shares the very same electricity provide with the auxiliary devices. The fluctuation of voltage should be no more than ten%, or it might lead to an abnormal operating of the program.

Leave a Reply

Your email address will not be published. Required fields are marked *